Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation

9.14. A steering wheel

Removal and installation

PERFORMANCE ORDER

The prevention The part of cars is equipped by a pillow of safety which is in the container in the steering wheel centre. To exclude casual operation of system the ignition switch translate in position Lock, disconnect from the battery from weight and wait not less than 2 minutes 1. Expose a wheel in driving position on a straight line and disconnect the battery from weight. 2. Disconnect the container with a safety pillow (if it is provided) (see subsection 11.44). 3. Hook and remove заглушки, located sideways on a wheel. 4. Turn away screws (with крестовой a head) fastenings of the container with a safety pillow. Turn out screws so that the screw flute has come into an edge обечайки. A reversing of screws at once stop. 5. Raise the case. 6. Take away a latch and get a socket of a pillow of safety. 7. Disconnect all sockets. Which can prevent wheel removal (for example, a socket of a sound signal). 8. Turn away a nut and designate position of a wheel concerning a shaft. 9. Press a stripper a steering wheel. It is forbidden to remove a wheel blows on a nave. The prevention After wheel removal it is forbidden to turn a shaft (or wheels) as centering of a spiral wire and a wire will be broken will break, because of what the safety pillow at failure will not work. At casual infringement restore centering before wheel installation. 10. Check up centering of a spiral wire of a pillow. 11. Be for this purpose convinced that wheels are exposed in position on a straight line and turn the coil case counter-clockwise against the stop and turn on clockwise on 3 turns, having combined labels. 12. Wheel installation is carried out upside-down. 13. Combine labels and tighten a nut with the set moment.