Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation


Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
- 9. A suspension bracket and a steering
   9.1. Specifications
   9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
   9.3. The stabilizer of a forward suspension bracket
   9.4. A rotary fist
   9.5. A forward nave and the bearing
   9.6. Spherical support
   9.7. The top lever
   9.8. The bottom lever
   9.9. Back shock-absorbers
   9.10. The back stabilizer of cross-section stability
   9.11. A cross-section bar of the back bridge
   9.12. Back springs
   9.13. Longitudinal bars of the back bridge
   9.14. A steering wheel
   9.15. A tip of steering draughts
   9.16. A cover of the steering mechanism
   9.17. The steering mechanism
   9.18. The hydraulic booster pump
   9.19. The wheel hydraulic booster
   9.20. Corners of installation of forward wheels
+ 10. A body
+ 11. An electric equipment
+ 12. Electroschemes

9.2. Springs and shock-absorbers (racks) of a forward suspension bracket
THE GENERAL DATA

Details of a rack of a forward suspension bracket

 1, 4. A plate

2, 5. A pillow

3. The top cup of a suspension bracket

6. A spring

7. The shock-absorber

8. The plug
The prevention

Keep in mind that procedure of removal of springs the extremely dangerous. For compression of springs use the regular checked up adaptation.

At replacement of springs or shock-absorbers separately consider that cost of separate details only ненамного more low than racks in gathering.

PERFORMANCE ORDER
1. Lift redock of the car and remove forward wheels.
2. Turn away a nut (it is specified by an arrow) and a bolt of fastening of a rack to the bottom lever.
3. Turn away three nuts of fastening of a rack to a frame arm (are specified by arrows).
The prevention

The central nut not to turn on.
4. Remove a rack.
5. Check up a condition of shock-absorbers, presence of dents, cracks and leak traces.
6. Check up a condition of coils of springs and durability of basic cups.
7. At detection of damages shock-absorbers and springs replace.
8. A new rack establish upside-down.
9. Clamp the bottom part of a rack in a vice through linings.
10. Compress a spring by means of the adaptation so that to release the top plate.
11. Turn out a rod nut, a key keeping a rod from проворачивания.
12. Remove a plate, a pillow and the top cup.
13. Remove the compressed spring and put in a safe place.
14. Remove the bottom plate and a pillow.
15. Check up a condition of pillows and the plates, the damaged details with cracks and deformations replace.
16. Assemblage and installation are carried out upside-down.


On the main page