Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
- 12. A suspension bracket and a steering
   12.1. A technical characteristics
   + 12.2. A rack of a forward suspension bracket
   12.3. Replacement of the bearing of a forward wheel
   + 12.4. The bottom lever of a forward suspension bracket
   12.5. Removal and installation of the forward stabilizer of cross-section stability
   12.6. Adjustment of the bearing of a back wheel
   + 12.7. A nave of a back wheel
   12.8. Replacement of the back shock-absorber
   + 12.9. The back stabilizer of cross-section stability
   12.10. Replacement of back springs
   12.11. Removal and installation of a back beam
   12.12. Replacement of the plug of the longitudinal lever of a back suspension bracket
   12.13. Replacement of elements of a back suspension bracket with sheet springs (Pickup)
   12.14. Check of system of a self-levelled back suspension bracket
   12.15. Removal and steering wheel installation
   + 12.16. A steering column
   12.17. Replacement of the cylinder of the lock and contact group of the lock of ignition
   12.18. Removal and installation of tips of steering draught
   - 12.19. Steering transfer
      12.19.1. Replacement elastic муфты a shaft of steering transfer
      12.19.2. Replacement of protective casings of steering transfer
      12.19.3. Removal and installation of the shock-absorber of steering transfer
      12.19.4. Removal, repair and installation of steering transfer
   12.20. Removal of air from system of a steering with the amplifier
   12.21. Removal and installation of the pump of the amplifier of a steering
   12.22. Removal and installation пополнительного a tank of hydraulic system
   12.23. Corners of installation of forward wheels
+ 13. A body
+ 14. Electric schemes

12.19.2. Replacement of protective casings of steering transfer
THE GENERAL DATA

The prevention

At installation it is necessary to use new clamps of a protective casing.


PERFORMANCE ORDER
1. Remove steering transfer.
2. Remove a clip and a rubber element from the left end face of steering transfer.
3. On steering transfer with the amplifier of a steering from the left end of steering transfer disconnect hydraulic tubes.
4. From two parties of steering transfer remove external clamps of a protective cover, then remove knot of a protective casing / of a pipe.
5. Remove internal clamps of a protective casing and remove a protective casing from a pipe.
6. Establish a new protective casing on a pipe and fix new clamps. Clamps should be placed so that after installation of steering transfer on the car the ends of clamps have been directed upwards.
7. Establish knot of a protective casing / of a pipe on steering transfer and fix its external ends the new clamps which ends should be directed upwards.
8. On models with the steering amplifier connect hydraulic tubes with new sealing rings.
9. Establish a clip and a rubber element and establish steering transfer on the car.


On the main page