Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   + 4.1. Engine OHV (with a camshaft in the block of cylinders)
   + 4.2. Engines OHC
   + 4.3. Engine DOHC with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   - 4.5. Diesel engines of 1,7 l
      4.5.1. A technical characteristics
      4.5.2. A method of removal of the engine
      4.5.3. Engine repair
      4.5.4. Replacement of engine oil and the oil filter
      + 4.5.5. Check, removal, installation and adjustment of a gear belt
      4.5.6. Check and adjustment timing
      4.5.7. Removal and installation of a head of the block of cylinders
      4.5.8. Removal and camshaft installation
      4.5.9. Removal and installation of the oil pallet
      4.5.10. Removal and installation of the oil pump
      4.5.11. Removal and installation перепускного the valve
      4.5.12. Removal and installation of the water pump
      4.5.13. Removal, check and thermostat installation
      4.5.14. Removal and installation of pistons and rods
      4.5.15. Removal and flywheel installation
      4.5.16. Replacement of sealing rings
      4.5.17. Replacement of support of the power unit
      4.5.18. Engine removal
      4.5.19. Engine repair
      4.5.20. Removal, repair and assemblage of the oil pump
      + 4.5.21. A head of the block of cylinders
      4.5.22. Check of elements of the engine
      4.5.23. Engine installation
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





4.5.19. Engine repair
PERFORMANCE ORDER
1. Remove following elements from the engine:
      – A head of cylinders;
      – The oil pallet (whenever possible try not to overturn the engine);
      – The oil pump;
      – Pistons and rods;
      – A flywheel and a drive plate.
2. Turn the engine.
3. Check up, that covers of radical bearings have been numbered from 1 to 4, since the party of a pulley of a cranked shaft. The fifth cover is not numbered, but it differs from the others. Number covers if they are not numbered.
4. Unscrew bolts of covers of radical bearings and remove covers.
5. Remove a cranked shaft.
6. Remove the top loose leaves of radical bearings.

On the main page