Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
+ 4.1. Engine OHV (with a camshaft in the block of cylinders)
+ 4.2. Engines OHC
- 4.3. Engine DOHC with 16 valves
4.3.1. A technical characteristics
4.3.2. Compression check
+ 4.3.3. The operations demanding removal of the engine
4.3.4. Removal of auxiliary components of the engine
4.3.5. Removal and installation of the valve of adjustment of pressure of oil
+ 4.3.6. A gear belt
4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers
4.3.8. Removal, check and installation of camshafts
+ 4.3.9. A head of the block of cylinders
4.3.10. Removal and installation of the oil pallet and маслоотражательной plates
+ 4.3.11. The oil pump
4.3.12. Removal and installation of the valve of the thermostat of an oil radiator
+ 4.3.13. Pistons and rods
4.3.14. Removal and flywheel installation
+ 4.3.15. Replacement of sealing rings
4.3.16. Removal, check and installation of bearings of a cranked shaft
4.3.17. Check of components of the engine
4.3.18. Removal and engine installation
4.3.19. Start of the engine after major repairs
+ 4.4. Diesel engines 16D and 16DА
+ 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes
|
The block of cylinders and the details located in the block of cylinders of engine DOHC, basically are similar to engine ONS of 2,0 l. Difference consists that pistons are attached to rods by piston fingers of floating type and are fixed by lock rings.
Camshafts on engines DOHC are resulted from a cranked shaft by one gear belt. In each cylinder it is established on four valves (two inlet and two final) which are put in action from camshafts through hydraulic pushers. One camshaft puts in action inlet the valve, and another – final.
Models with engines DOHC have a separate oil radiator.
The ignition distributor is put in action from a camshaft operating final valves.
The gear belt also puts in action the water pump, but for adjustment of a tension of a gear belt the additional roller is used. Also there is one more directing roller of a gear belt. |
On the main page
|