Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
+ 4. The engine
+ 5. System of cooling, heating and ventilation
- 6. Fuel and exhaust systems
   + 6.1. Models with the carburettor
   - 6.2. Models with system of injection of fuel
      6.2.1. A technical characteristics
      6.2.2. Removal and installation of the case of the air filter
      6.2.3. Removal, installation and adjustment of a cable of an accelerator
      6.2.4. Used fuel
      + 6.2.5. System of injection of fuel
      6.2.6. Pressure removal in fuel system
      6.2.7. Removal and installation of the fuel pump
      6.2.8. Removal and installation of the gauge of level of fuel
      6.2.9. Removal and installation of a fuel tank
      6.2.10. Check and adjustment of system of injection of fuel
      6.2.11. Removal and installation of elements of one-dot system of injection of fuel
      + 6.2.12. Removal and installation of elements of multidot system of injection of fuel
      6.2.13. Removal and installation of an inlet collector
      6.2.14. Removal and installation of a final collector
      6.2.15. Removal and exhaust system installation
   + 6.3. Models with engines 16D and 16DA
   + 6.4. Models with engines 17D and 17DR
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





6.2.14. Removal and installation of a final collector

Removal

PERFORMANCE ORDER
Models 2,0 with 16th valves
1. Lift a forward part of the car and fix on supports.
2. Remove a wire of weight from the accumulator.
3. Remove a thermofilter of a collector which from above fastens three bolts, and from below – two nuts of fastening of a collector.
4. Unscrew 10 nuts, крепящих a final collector.
5. On models with the oxygen gauge disconnect an electric socket of the gauge which is about the top fastening of the right suspension bracket, and release the wires going to the gauge. Working under the car, unscrew a bolt of elastic fastening of a final collector and an arm.
6. Remove a final collector and a collector lining.

Other models

7. Look the corresponding description in subsection 6.1.16. On models with the oxygen gauge disconnect an electric socket of the gauge of oxygen and release the wires going to the gauge not to damage a wire at collector removal.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. At collector installation it is necessary to use a new lining.

On the main page