Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
- 11. An electric equipment
11.1. Specifications
11.2. The battery
+ 11.3. Ignition system
11.4. The coil () ignitions
11.5. The ignition distributor
11.6. Check and installation of the moment of ignition
11.7. The block of electronic ignition
11.8. The induction gauge
+ 11.9. System of a charge of the battery
+ 11.10. The generator
11.11. System of start-up of the engine
+ 11.12. The starter electric motor
11.13. The traction relay
11.14. Pressure check
11.15. Short circuit detection
11.16. Check of reliability of grounding
11.17. Check of integrity of a chain
11.18. A finding of not closed chain
11.19. Search of malfunctions
11.20. Safety locks
11.21. Fusible crosspieces
11.22. Breakers
11.23. The relay
11.24. The breaker of indexes of turn / of the alarm system
11.25. The switch of indexes of turn
11.26. The lock of ignition and a lock drum
11.27. The switch of external illumination
11.28. The screen wiper switch
11.29. Lamps of headlights
11.30. Adjustment of headlights
11.31. The headlight case
11.32. Replacement of lamps
11.33. The receiver and dynamics
11.34. The aerial
+ 11.35. The screen wiper electric motor
11.36. The switch of heating of back glass
11.37. A heater of back glass
11.38. A guard of devices
11.39. A sound signal
11.40. The electric drive of mirrors
11.41. Cruise-control
+ 11.42. The electric drive window lifterа
11.43. The electric drive of door-locks
11.44. Safety pillows
+ 12. Electroschemes
|
Pressure check is necessary for spending, if the electric chain is faulty.
Connect one of probeов a control bulb to the negative plug of the accumulator or (weight) of the car. Connect the second probe to connection in a checked chain, it is desirable located as it is possible more close to the accumulator or a safety lock.
If the control bulb lights up, pressure is present. It means that the chain part between connection and the accumulator is serviceable.
Continue check of other part of a chain in the same way.
When you will find a point where pressure is absent, it means that the malfunction source lies between this point and last point where pressure was present. The majority of problems is caused by bad connection.
The prevention Do not forget that pressure is present at some chains only if to turn a key in the ignition lock in certain position.
|
On the main page
|