Contactless system of ignition |
1. Disconnect the battery from weight. |
|
2. Turn away screws (are specified by arrows). |
|
3. Remove a thermal guard of the coil. |
|
4. Turn away a nut (are specified by arrows) contacts. |
|
5. Check up resistance of a primary chain of the coil (between (+) and (-) coil conclusions). |
|
6. Check up resistance of a secondary chain of the coil (between (+) and (-) coil conclusions). |
7. If both resistance differ from standard the ignition coil replace. |
8. For replacement designate and disconnect wires. |
|
9. Turn away bolts (are specified by arrows). |
|
10. Get the coil from the distributor case. |
11. Installation is carried out upside-down. |
DIS-system |
12. Translate a key ignition in position Off, disconnect sockets from coils. |
|
13. Check up resistance of a primary chain of the coil. |
|
14. Check up resistance of a secondary chain of the coil. |
15. If resistance differ from standard the ignition coil replace. |
16. For replacement designate and disconnect from the coil all sockets. |
|
17. Turn away bolts and remove the coil. |
18. Installation is carried out upside-down. |