|
1. Connect a tachometre, being guided by the instruction of the manufacturer of the device 1 – a tachometre, 2 – the battery). |
|
2. Find a diagnostic socket and close накоротко conclusions Е1 and ТЕ1 (the place of installation of a socket is specified in subsection 5.10). |
| 3. At the switched off ignition connect a stroboscope, being guided by the instruction of the manufacturer of the device. Almost all stroboscopes eat from the battery. Besides, on a high-voltage wire of 1st cylinder the winding of the induction gauge of a stroboscope puts on. |
|
4. Find labels of the moment of ignition on a forward cover and on a pulley коленвала. |
| 5. Warm up the engine, be convinced that turns of idling of the engine correspond to norm. |
|
6. Direct stroboscope light on a scale. The label on a pulley коленвала should be opposite to corresponding division of a scale. |
| 7. If necessary ослабьте a bolt of fastening of the distributor and slowly turning the distributor, establish the ignition moment (subsection 11.1 see). |
| 8. Tighten a bolt of the distributor and again check up installation of the moment of ignition. |
| 9. Remove a crosspiece and be convinced that the corner of an advancing of ignition corresponds to norm. |
| 10. Switch off ignition and remove devices. |