Audi A3

Since 1997 of release

THE GENERAL DATA

To removal of a forward bumper

1 – bumper facing
2 – a bolt, 25 Н•м
3 – a bolt шестигранный, 6 Н•м
4 – a bumper
5 – a directing element

6 – саморез, 1.5 Н•м
7 – the buffer
8 – a clip
9 – the screw with crosswise шлицем

Elements of a back bumper

1 – a peak
2 – саморез
3 – a cover
4 – bumper facing
5 – a nut, 23 Н•м

6 – a bumper
7 – a directing element
8 – саморез, 1.5 Н•м
9 – the amplifier
10 – саморез, 1 Н•м

Forward bumper

REMOVAL

PERFORMANCE ORDER

1. Press through a thin pin an insert (the marksman on an illustration) on a clip–8 and take out it.
2. Turn out on three screws Torx (T25) on a wheel casing at the left and on the right.
3. Turn out screws with crosswise шлицем–9 from the bottom party.
4. Disconnect bumper facing above at a directing element–5.
5. Disconnect bumper facing sideways over wheel casings and remove forward from a bumper.
	6. Turn out bolts of fastening–2 support–1 bumpers–3.
	7. Turn out screws with internal шестигранником–5 on both shock-absorbers–1.
8. Take out a bumper–4 of the shock-absorber and remove it forward.

INSTALLATION

PERFORMANCE ORDER

1. Put on a bumper–4 shock-absorbers–1.
2. Screw screws with internal шестигранником–5 and tighten the moment 23 Н•м.
	3. Tighten bolts of fastening–2 support of a bumper the moment 6 Н•м, address to an illustration.
4. Establish in front facing–1 (address to an illustration To removal of a forward bumper) and correct it sideways over wheel casings.
5. Fix bumper facing in a directing element–5.
6. Tighten from the bottom party screws with crosswise шлицем.
7. Fix bumper facing at the left and on the right three screws Torx c each party to локерам arches of wheels.
8. Insert clips–8 into apertures above at facing of a bumper and press pins (arrow) so that they have completely entered into a clip, address to a fragment on an illustration To removal of a forward bumper.

Back bumper

REMOVAL

PERFORMANCE ORDER

1. Remove overlays–1 at the left and on the right for what turn on саморезы.
2. Uncover–3.
3. Turn on саморезы fastenings of the amplifier-10 and remove the amplifier–9.
4. Turn out at the left and on the right at wheel casings on 3 самореза.
5. Take out facing of a bumper–4 from above from a directing element–7.
6. Hook bumper facing sideways over локерами arches of wheels and remove back.
7. Turn away a nut–5 and remove a bumper–6.

INSTALLATION

PERFORMANCE ORDER

1. Establish into place a bumper and fix its nuts–5.
2. Correct facing of a bumper–4 sideways over wheel casings and insert from above into directing element–7.
3. Screw at the left and on the right in локеры arches of wheels on 3 самореза.
4. Put the amplifier–9 and fix it саморезами-10.
5. Put a cover–3.
6. Establish overlays–1 at the left and on the right and fix them саморезами–2.

On the main page