Replacement of elastic bands of brushes of screen wipers
At bad quality of clearing of glass it is necessary to replace brushes of screen wipers. On sale are available as complete screen wipers (rubber with the holder), and separate brushes. If rubber is replaced only, watch to bending the holder.
ATTENTION
If brushes движутся, as a rule, it is not enough to replace with jerks brushes or rubber. Just in case it is necessary to check up and if necessary to adjust corner of installation of levers, thus address to subsection Removal and installation, check and adjustment of final position of levers of a screen wiper.
REMOVAL
| PERFORMANCE ORDER |
| 1. Cast away upwards the lever, put a brush at right angle to the lever. |
| 2. Press a spring clip () (an arrow direction) and displace a brush downwards () from a hook on the lever. Unhook a lever brush. | | 3. Compress пассатижами both steel tyres on the closed party of rubber and take out them from top скобы. Then take out rubber completely with tyres from remained скоб brushes. |
|
INSTALLATION
|
PERFORMANCE ORDER |
| 1. Enclose freely new rubber without tyres in bottom скобы brushes. | | 2. Enter both tyres into the first flute of rubber so that grooves of tyres showed towards rubber and fix in rubber pads of a flute. | | 3. Compress both steel tyres and rubber пассатижами and thus insert in top скобу that pads скобы from both parties have been fixed in tightening grooves (an arrow on an illustration) rubbers. | | 4. Insert rubber through the lever and fix spring скобы in lever hooks. Обтекатель on a brush if it is available, should look downwards. | | 5. Lower the lever back. Watch that rubber everywhere adjoined to glass, otherwise cautiously turn in the holder. | |
| |
|