Audi A3

Since 1997 of release

Repair and car operation


Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
- Systems of cooling, heating
   + System of cooling of the engine
   - Systems of ventilation, heating and air conditioning
      The general information and security measures
      Removal and installation air дефлекторов
      Removal and installation of a nozzle of area of feet
      Removal and installation of a drive of a heater/replacement of a lamp
      Removal and installation of cables of a drive of management of a heater
      Removal and installation of the fan of fresh air
      Removal and installation of the additional resistor
      The conditioner
      Removal and compressor installation
      Conditioner diagnostics on codes on the display of the block of its management
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Removal and installation of cables of a drive of management of a heater

 REMOVAL

PERFORMANCE ORDER
1. Remove a heater drive.
2. Disconnect a support of draughts ().
3. Disconnect draughts () at a heater drive.
4. Remove a nozzle of area of feet, address to subsection Removal and installation of a nozzle of area of feet.
5. Hook a screw-driver and remove скобы () support of a drive of a heater on a heater casing.
6. Cautiously remove draughts from levers () and ().
INSTALLATION
7. Before installation check up draughts of a heater on ease of a course. In the presence of jammings or draught damages replace.
ATTENTION

At assemblage of draught of a heater fix collars and clips so that they did not concern mobile parts.

Connection of cables with the heater control panel
8. Connect cables () so that the winding has been turned downwards.
9. Connect a green cable () заслонки nozzles of defrosting of glasses/areas of feet to the lever of a drive of a heater. Fix a support.
10. Connect a yellow cable () заслонки nozzles of defrosting of glasses to the lever of a drive of a heater. Fix a support.
11. Connect a brown cable () заслонки nozzles of defrosting of glasses to the lever of a drive of a heater. Fix a support.
12. Establish a heater drive.
Connection of cables with the heater case
13. Connect a green cable () to the lever заслонки nozzles of defrosting of glasses/areas of feet. A support yet do not fix.
14. Connect a yellow cable () to the lever central заслонки.
15. Connect a brown cable () to the lever temperature заслонки.
Adjustment of draughts of a heater
16. Turn the handle of a choice of temperature against the stop in position «kalt» ("coldly").
17. Slightly press the lever () on a heater box in an arrow direction. In this position fix draught on a support скобой ().
18. Turn the handle of the distributor of air against the stop in position of distribution of air to a windscreen.
19. Slightly press the lever () central заслонки in an arrow direction, address to an illustration in point 17. In this position fix draught on a support скобой ().
20. Press the lever () заслонки defrosting of glasses/areas of feet in a direction of an arrow and fix draught on a support скобой ().
21. Turn every which way both handles between an extreme emphasis, they should concern both emphasis.
22. Remove a nozzle of area of feet, address to subsection Removal and installation of a nozzle of area of feet.
On the main page