Audi A3

Since 1997 of release

Repair and car operation


Audi A3
+ The maintenance instruction
+ Current leaving and service
+ The engine
- Systems of cooling, heating
   + System of cooling of the engine
   - Systems of ventilation, heating and air conditioning
      The general information and security measures
      Removal and installation air дефлекторов
      Removal and installation of a nozzle of area of feet
      Removal and installation of a drive of a heater/replacement of a lamp
      Removal and installation of cables of a drive of management of a heater
      Removal and installation of the fan of fresh air
      Removal and installation of the additional resistor
      The conditioner
      Removal and compressor installation
      Conditioner diagnostics on codes on the display of the block of its management
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes

Removal and installation of a drive of a heater/replacement of a lamp
THE GENERAL DATA

Switch illumination is carried out by an optical path, there is only one lamp накаливания. For lamp replacement remove the fan switch. A lamp take out from a cartridge flat-nose pliers. Since the middle of 1997 of release replacement by a light-emitting diode (LED) is made. Last is not replaced.

REMOVAL

PERFORMANCE ORDER
1. Remove a radio receiver, address to subsection Removal, installation and radio receiver coding.
2. Remove an overlay of switches ().
3. Turn away 4 screws of fastening () the management block. Thus pay attention to position скоб () for the subsequent assemblage.
4. Remove the forward central console (D), address to subsection Removal and installation of the bottom central console.
5. Remove cables of the block of management, address to subsection Removal and installation of cables of a drive of management of a heater.
INSTALLATION
6. Fix cables on the block of management and adjust them, address to subsection Removal and installation of cables of a drive of management of a heater.
7. Establish the forward central console, address to subsection Fusible inserts.
8. Fix a heater drive to the central part of the panel of devices the moment 5 Н m.
9. Establish an overlay of switches.
10. Establish a radio receiver, address to subsection Removal, installation and radio receiver coding.

On the main page