Toyota 4 Runner/Hilux/Surf

1987-1998 of release

Repair and car operation



Тойота 4Раннер
+ 1. The maintenance instruction
+ 2. Maintenance service
+ 3. Engines
+ 4. Systems of heating, ventilation
+ 5. Fuel and exhaust systems
+ 6. Transmissions
+ 7. Transmission elements
+ 8. Brake system
+ 9. A suspension bracket and a steering
+ 10. A body
- 11. An electric equipment
   11.1. Specifications
   11.2. The battery
   - 11.3. Ignition system
      11.3.1. Check of system of ignition
   11.4. The coil () ignitions
   11.5. The ignition distributor
   11.6. Check and installation of the moment of ignition
   11.7. The block of electronic ignition
   11.8. The induction gauge
   + 11.9. System of a charge of the battery
   + 11.10. The generator
   11.11. System of start-up of the engine
   + 11.12. The starter electric motor
   11.13. The traction relay
   11.14. Pressure check
   11.15. Short circuit detection
   11.16. Check of reliability of grounding
   11.17. Check of integrity of a chain
   11.18. A finding of not closed chain
   11.19. Search of malfunctions
   11.20. Safety locks
   11.21. Fusible crosspieces
   11.22. Breakers
   11.23. The relay
   11.24. The breaker of indexes of turn / of the alarm system
   11.25. The switch of indexes of turn
   11.26. The lock of ignition and a lock drum
   11.27. The switch of external illumination
   11.28. The screen wiper switch
   11.29. Lamps of headlights
   11.30. Adjustment of headlights
   11.31. The headlight case
   11.32. Replacement of lamps
   11.33. The receiver and dynamics
   11.34. The aerial
   + 11.35. The screen wiper electric motor
   11.36. The switch of heating of back glass
   11.37. A heater of back glass
   11.38. A guard of devices
   11.39. A sound signal
   11.40. The electric drive of mirrors
   11.41. Cruise-control
   + 11.42. The electric drive window lifterа
   11.43. The electric drive of door-locks
   11.44. Safety pillows
+ 12. Electroschemes





11.3.1. Check of system of ignition

CONTACTLESS SYSTEM

PERFORMANCE ORDER
1. If the engine is not started, and the starter rotates коленвал check up spark presence.
2. For this purpose disconnect a wire from one of candles, take away isolating tip and fix a wire on distance about 6 mm from the bared site of weight, or connect to the calibrated rated sportsman. Include a starter and watch a candle wire. There should be an intensive spark of blue colour.
3. If the spark is available, turn out candles and check up.
4. If the spark is absent, or искрообразование unstable uncover the distributor and check up a condition of a cover and бегунка.
5. At moisture detection wipe dry a cover and бегунок, establish a cover into place and repeat check.
6. If sparks on former are not present, disconnect from a distributor cover a high-voltage wire of the coil of ignition and fix a wire on distance about 6 mm from the bared site of weight.
7. If the spark has appeared, malfunction of a cover of the distributor or бегунка can be the reason.
8. In the absence of a spark check up all conducting of a primary chain of the coil of ignition.
9. Whether check up pressure on the coil from the ignition key arrives.
10. Check up the ignition coil (subsection 11.4 see) and the induction gauge.
11. If the spark on the former is absent, replace a high-voltage wire of the coil obviously serviceable.
12. If replacement does not give result the electronic block is faulty.

DIS-СИСТЕМА

PERFORMANCE ORDER
1. If the engine is not started, and the starter rotates коленвал disconnect a wire from a candle of the left cylinder and connect to a test rated sportsman. The rated sportsman should be calculated on check DIS - systems.

The prevention

For check use wires from the left head of cylinders as for access to coils of the right cylinders it is complicated and dismantling is required.


2. If the spark is observed, turn out candles and check up.
3. If the spark is absent, or искрообразование unstable check up pressure from the battery on each coil, check up coils and gauges (subsection 11.4 see).
4. Check up a signal from the electronic block on coils.
5. For this purpose open a socket and attach to a socket conclusion on which a food from the battery, a control light-emitting diode moves. At rotation коленвала the light-emitting diode should light up at the moment of arrival of a signal from the electronic block.
6. Electronic and processor blocks are checked in car-care centre.

On the main page