Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
- 12. A body, salon
12.2. The central section of a guard
12.3. A cowl rope
12.4. A forward guard
12.5. A forward wing
12.6. Lock pins of a cowl, the rubber shock-absorber
12.7. A cowl
12.8. A gazonapolnennaja rack (models the Sedan)
12.9. A luggage carrier cover
12.10. A back door (Compartment model)
12.11. A forward door, the bottom door loop
12.12. Adjustment of a window and a bearing element of a door
12.13. Window condensing stoppers, a window regulator
12.14. The door lock
12.15. Draught of lever transfer of the lock
12.16. A rope of an internal door-lock
12.17. A rotary clamp, an adjusting spring
12.18. Adjustment of doors
12.19. A bearing element of a door
12.20. The central lock
12.21. The pump with two modes of forcing
12.22. The leading activator
12.23. The activator of a back door
12.24. The activator of a cover of a luggage carrier
12.25. The activator of a cover of a fuel tank
12.26. Door glass (Compartment model)
12.27. Adjustment of a butt overlay (Compartment model)
12.28. A skeleton of a back door, the bottom loop of a door
12.29. A bearing element of the back door, a condensing stopper
12.30. A rope, шарнирный the lever
12.31. The door handle
12.32. The holder of components of a door
12.33. The hatch
12.34. A bumper casing
12.35. Hermetic sealing of a back bumper
12.36. An extending clamp
12.37. A forward spoiler / a lining of a niche of a wheel (Compartment model)
12.38. The top overlay of a forward spoiler (Compartment model)
12.39. A back spoiler / a lining of a niche of a wheel
12.40. A back bumper (Compartment model)
12.41. window raiser
12.42. Internal furnish of a body
12.43. Sitting
+ 13. A central air
+ 14. An electric equipment
|
Rotary clamp, installation
|
|
And = a lock clamp in the closed position In = the lock clamp is removed
The groove 1 on a lock clamp should settle down on one line |
Adjusting spring, installation
|
|
During an inhaling the ends of a spring 1 should settle down on the right and to the left of a control lever 2. The preliminary inhaling always pushes away a control lever and the lock cylinder in the central position. |
Rotary clamp, installation (Compartment model)
|
|
And = a lock clamp in the closed position In = the lock clamp is removed
The groove 1 on a lock clamp should settle down on one line |
Adjusting spring, installation (Compartment model)
|
|
During an inhaling the ends of a spring 1 should settle down on the right and to the left of a control lever 2. The preliminary inhaling always pushes away a control lever and the lock cylinder in the central position. |
|
On the main page
|