Two washers with чашеобразной dredging can be in case of need established.
Adjustment of a bearing element of components of a door
The window and door skeleton too should be adjusted.
| PERFORMANCE ORDER |
|
|
1) ослабьте bolts |
| 2) close a door |
| 3) press on bearing element of components of a door in a direction opposite to a roof and a rack |
| 4) the assistant should tighten at first bottom, and then the top bolts |
| 5) 20 Н.м. |
| 6) be convinced that the bearing element is established, having pressed on top more strongly |
| 7) do not press a door skeleton |
| 8) check up all the sizes long |
|
The holder of components of a door, the sizes
|
|
In drawing the cross-section section of the left door is shown
With = 3.5 + 1 mm
d = 8.1 + 1 mm
1 – a sealing flange
2 – a door frame
3 – a decorative overlay of a door
4 – a window
5 – a window sealing lining
6 – an internal door sealing lining
7 – a sealant
8 – a sealant at a window |
The sealing edge 7 should have contact on all contour of a rack and a decorative overlay of a roof 3
The external sealing flange of a window 8 should not support a decorative overlay of a roof 3 |