Citroen Xantia

1. In impellent, manipulating operating lever TNVD, disconnect from it the core of a cable of gas.

2. Liberate a cover of a cable from the plug through passage in a pump arm.

3. Liberate a cable from the remained intermediate clamps and arms in an impellent compartment. Try to remember a route of its lining precisely.
4. In car salon release clamps and remove the bottom felt section of furnish of the panel of devices in a driver's foot well.
5. Having turned on a turn quarter counter-clockwise, release a clamp and uncover the assembly block of safety locks. Having released the remained clamps, remove the bottom felt cover established under the panel of devices from the driver's party of the car.
6. Release a clamp and disconnect the core of a cable from a gas pedal.
7. Liberate a cover of a cable from an arm on a gas pedal.
8. Accurately push a cable through the plug through passage from an impellent compartment in salon and remove it from the car.

1. Remove from a cover of a cable of gas a spring clamp. Make sure that operating lever TNVD is pressed to an emphasis, then cautiously pull a cable from the plug through passage, completely choosing a weak point of its core.
2. Having fixed a cable this position, establish a spring clamp in last from visible flutes in front of the rubber plug through passage and a washer. After отпускания covers the cable core should receive the minimum weak point.
3. Ask the assistant to squeeze out a pedal of gas and make sure of completeness of moving of operating lever TNVD. At release pedals the lever should come back in a starting position, nestling on an emphasis.