Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system and release
   + The power supply system - petrol models
   - The power supply system - diesel models
      Filling of the power supply system with fuel and removal from it air stoppers
      Check and adjustment of the maximum turns of the engine
      Removal, installation and adjustment of the thermosensitive gauge of turns of fast idling
      Electromagnetic запорный the valve - the general data, removal and installation
      Removal and installation ТНВД
      Methods of check of installation of the moments of injection of fuel
      Check and adjustment of the moments of injection (ТНВД Lucas)
      Check and adjustment of the moments of injection (ТНВД Bosch)
      Check of serviceability of functioning, removal and installation of atomizers of injection of fuel
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Removal and assemblage installation топливозаборника with the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation of the inlet pipeline and final collector
      turbocharger - the general data and safety measures
      Removal and installation турбокомпрессора
      Check of a condition and regenerative repair турбокомпрессора
      Removal and installation of the built in cooler турбокомпрессора
      Removal and installation of an air cleaner and accompanying components
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of the built in cooler турбокомпрессора

Removal

 PERFORMANCE ORDER

1. The cooler is located before a radiator of system of cooling which should be removed preliminary (see the Head of System of cooling, heating).
2. Disconnect the air hoses brought to assemblage of a cooler from its both parties, then remove assemblage from a forward cross-section beam.

Installation

Installation is made upside-down.


On the main page