Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
- The power supply system and release
   + The power supply system - petrol models
   - The power supply system - diesel models
      Filling of the power supply system with fuel and removal from it air stoppers
      Check and adjustment of the maximum turns of the engine
      Removal, installation and adjustment of the thermosensitive gauge of turns of fast idling
      Electromagnetic запорный the valve - the general data, removal and installation
      Removal and installation ТНВД
      Methods of check of installation of the moments of injection of fuel
      Check and adjustment of the moments of injection (ТНВД Lucas)
      Check and adjustment of the moments of injection (ТНВД Bosch)
      Check of serviceability of functioning, removal and installation of atomizers of injection of fuel
      Removal, installation and adjustment of a cable of gas
      Removal and installation of a pedal of gas
      Removal and assemblage installation топливозаборника with the gauge of the expense of fuel
      Removal and installation of a fuel tank
      Removal and installation of the inlet pipeline and final collector
      turbocharger - the general data and safety measures
      Removal and installation турбокомпрессора
      Check of a condition and regenerative repair турбокомпрессора
      Removal and installation of the built in cooler турбокомпрессора
      Removal and installation of an air cleaner and accompanying components
   + Systems of decrease in toxicity and release of the fulfilled gases
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of an air cleaner and accompanying components

Removal

Air cleaner (models without a turbo-supercharging)

 PERFORMANCE ORDER

1. Release collars of fastening of an air cleaner to an air sleeve of the inlet pipeline. Where it is required, turn out a bolt of fastening of a sleeve. Disconnect a sleeve and remove it from the engine. On engines D9V remove about a sealing lining from a casing воздухораспределителя.
2. Turn out a bolt of fastening of an inlet air line to a cross-section beam, then liberate a sleeve from clamps on a wall of an air cleaner and remove it from the car.
3. Give fixing bolts and remove assemblage of an air cleaner with a basic arm from the car.

Air cleaner (models with a turbo-supercharging)

 PERFORMANCE ORDER

1. Release collars of fastening of an air cleaner to an air sleeve of the inlet pipeline. Give a bolt of fastening of a sleeve. Take assemblage of an air sleeve from an impellent compartment. Remove the sealing lining, the sleeves established from both parties.
2. Turn out a bolt of fastening of an inlet air line to a cross-section beam, then liberate a sleeve from clamps on a wall of an air cleaner and remove it from the car.
3. Turn out fixing bolts and take an air cleaner from an impellent compartment.

Casing воздухораспределителя (models without a turbo-supercharging with engine D9V)

 PERFORMANCE ORDER

1. Disconnect an air hose and a ventilation hose картера from a forward part of a casing воздухораспределителя.

2. Turn out two bolts of fastening of a casing to lobbies assembly скобам. Remove remote washers.

3. Turn out four bolts of fastening of a casing воздухораспределителя to the inlet pipeline. Remove washers.

4. Remove a casing воздухораспределителя from the inlet pipeline. Remove a sealing lining ().

Installation

Installation is made upside-down. Do not forget to check a condition and, in case of need, to make replacement of sealing linings.

On the main page