Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   + 4.1. Engine OHV (with a camshaft in the block of cylinders)
   + 4.2. Engines OHC
   - 4.3. Engine DOHC with 16 valves
      4.3.1. A technical characteristics
      4.3.2. Compression check
      + 4.3.3. The operations demanding removal of the engine
      4.3.4. Removal of auxiliary components of the engine
      4.3.5. Removal and installation of the valve of adjustment of pressure of oil
      + 4.3.6. A gear belt
      4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers
      4.3.8. Removal, check and installation of camshafts
      + 4.3.9. A head of the block of cylinders
      4.3.10. Removal and installation of the oil pallet and маслоотражательной plates
      + 4.3.11. The oil pump
      4.3.12. Removal and installation of the valve of the thermostat of an oil radiator
      + 4.3.13. Pistons and rods
      4.3.14. Removal and flywheel installation
      + 4.3.15. Replacement of sealing rings
      4.3.16. Removal, check and installation of bearings of a cranked shaft
      4.3.17. Check of components of the engine
      4.3.18. Removal and engine installation
      4.3.19. Start of the engine after major repairs
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers Removal

PERFORMANCE ORDER

1. Remove a gear belt.

2. Unscrew a bolt, крепящий the mechanism of a tension of a gear belt, then remove the tension mechanism, a basic plate and the plug.

3. Similarly unscrew a bolt and remove directing roller and the plug. If at work rollers publish noise or a roller surface has defects, replace rollers.

Installation

PERFORMANCE ORDER

1. Installation is made in sequence, return to removal, taking into account following moments.

2. At installation correctly arrange plugs. The plug of the mechanism of a tension in smaller diameter should be directed to the block of cylinders, and the plug of an intermediate roller in smaller diameter should be directed from the block of cylinders.

3. Tighten bolts the demanded moment.

4. Establish a new gear belt.

On the main page