Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   + 4.1. Engine OHV (with a camshaft in the block of cylinders)
   + 4.2. Engines OHC
   - 4.3. Engine DOHC with 16 valves
      4.3.1. A technical characteristics
      4.3.2. Compression check
      + 4.3.3. The operations demanding removal of the engine
      4.3.4. Removal of auxiliary components of the engine
      4.3.5. Removal and installation of the valve of adjustment of pressure of oil
      + 4.3.6. A gear belt
      4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers
      4.3.8. Removal, check and installation of camshafts
      + 4.3.9. A head of the block of cylinders
      4.3.10. Removal and installation of the oil pallet and маслоотражательной plates
      + 4.3.11. The oil pump
      4.3.12. Removal and installation of the valve of the thermostat of an oil radiator
      + 4.3.13. Pistons and rods
      4.3.14. Removal and flywheel installation
      - 4.3.15. Replacement of sealing rings
         4.3.15.1. A forward sealing ring of a camshaft
         4.3.15.2. A forward sealing ring of a cranked shaft
         4.3.15.3. A back sealing ring of a cranked shaft
      4.3.16. Removal, check and installation of bearings of a cranked shaft
      4.3.17. Check of components of the engine
      4.3.18. Removal and engine installation
      4.3.19. Start of the engine after major repairs
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.3.15. Replacement of sealing rings

4.3.15.1. A forward sealing ring of a camshaft
THE GENERAL DATA

The prevention

At installation of a sealing ring of a camshaft it is necessary to use a new gear belt.


PERFORMANCE ORDER
1. It is possible to replace a forward sealing ring of a camshaft on the engine established in the car.
2. Remove a gear belt and a corresponding pulley of a camshaft.
3. Drill in a sealing ring two small apertures located in the opposite ends of consolidation. Screw in two self-cutting screws in the drilled apertures of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
4. Clear a nest of a sealing ring.
5. Turn a camshaft in such position that the adjusting pin was in the top position, then grease working edges of a new sealing ring with engine oil and establish a sealing ring.
6. For installation of a sealing ring use tubular оправку the corresponding diameter and the big washer and, screwing a bolt of fastening of a pulley of a camshaft, press a sealing ring into a nest.
7. If necessary similarly replace a sealing ring of the second camshaft.
8. Establish pulleys of camshafts and a gear belt. Adjust a tension of a gear belt.


On the main page