Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
- Coupling
   Specifications
   + Flywheel and coupling
   - Приводные and карданный shaft, back differential
      Drive of forward wheels - the general information
      Removal and installation of rotary fists, service ступичных assemblages of forward wheels
      Removal, service and installation of a forward power shaft
      Drive of back wheels - the general information
      Removal and installation ступичных assemblages of back wheels, replacement back ступичного the bearing
      Removal, check of a condition and installation of components карданного a shaft
      Check of a condition and replacement of a forward epiploon of back differential
      Removal, service, installation and adjustment of back differential of T-type
      Removal, service, installation and adjustment of back differential of VA-type
      Removal, installation and check of a condition of a forward beam of fastening of back differential
      Removal, service and installation of a back power shaft
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal, installation and check of a condition of a forward beam of fastening of back differential

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Поддомкратьте the car.

3. Special трансмиссионным a jack prop up back differential and remove a forward beam of its fastening.

Efforts of a tightening of carving connections, Nanometer

Т1: 65
Т2: 110

4. Check up a forward beam of fastening of back differential on presence of damages, deformations or corrosion and if necessary replace it.
5. Check up plugs of a forward beam of fastening of back differential on presence of damages, cracks or hardenings and if necessary replace them.
6. Installation is made in an order, the return to an order of dismantle of components. Track that all fixture has been tightened with demanded effort.

On the main page