Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Prorolling of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement колодок disk brake mechanisms of forward wheels
   Replacement колодок disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, major repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, major repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   Lay brake - the general data and adjustments
   Removal and installation of a control lever of a lay brake
   Removal and installation of cables of a drive of a lay brake
   Removal and installation of the gauge-switch of stoplights
   System of antiblocking of brakes (ABS) - the general information
   Removal and installation of components of system of antiblocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of a control lever of a lay brake

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove the central console (address to the Head the Body and salon furnish).

3. At a corresponding complete set liberate the block of management of the uniform lock from a bearing arm on a salon floor. On the models equipped натяжителями of seat belts, shift an arm aside for the purpose of providing of access to nuts of fastening of a control lever of a lay brake, - try not to suppose натягивания electroconducting of the block of management натяжителями.

4. Disconnect приводные cables of a lay brake from supports of brake mechanisms (Removal and installation of cables of a drive of a lay brake see).
5. Liberate from an arm behind assemblage of a control lever the gauge-switch of a control lamp of raising of a lay brake, disconnect corresponding electroconducting.

6. Disconnect from a control lever a primary cable of a drive of a lay brake.

7. Give three fixing nuts and remove assemblage of a control lever of a lay brake.

Installation

Installation is made upside-down. Having finished lever installation, check up adjustment of a drive of a lay brake (the Lay brake - the general data and adjustments see).

On the main page