Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Prorolling of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement колодок disk brake mechanisms of forward wheels
   Replacement колодок disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, major repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, major repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   Lay brake - the general data and adjustments
   Removal and installation of a control lever of a lay brake
   Removal and installation of cables of a drive of a lay brake
   Removal and installation of the gauge-switch of stoplights
   System of antiblocking of brakes (ABS) - the general information
   Removal and installation of components of system of antiblocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of the gauge-switch of stoplights

Removal

 PERFORMANCE ORDER

1. The Gauge-switch is built in a rubber emphasis of a pedal of a foot brake.
2. Disconnect a negative wire from the battery.
3. Release fixing clamps and remove the bottom section of furnish of the panel of devices in a driver's foot well.
4. In the top part of a pedal disunite a socket of electroconducting of the gauge-switch of stoplights.
5. Liberate electroconducting from a pedal.

6. Under a pedal, give a fixing nut and remove assemblage of a rubber emphasis with the gauge-switch built in in it.

Installation

Installation is made upside-down. Track reliability of fixing of electroconducting on pedal assemblage.

On the main page