Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Prorolling of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement колодок disk brake mechanisms of forward wheels
   Replacement колодок disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, major repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, major repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   Lay brake - the general data and adjustments
   Removal and installation of a control lever of a lay brake
   Removal and installation of cables of a drive of a lay brake
   Removal and installation of the gauge-switch of stoplights
   System of antiblocking of brakes (ABS) - the general information
   Removal and installation of components of system of antiblocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes





Removal, major repairs and installation of supports of disk brake mechanisms of forward wheels

The preventions resulted in section Brake system see.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove brake Pads (Replacement колодок disk brake mechanisms of forward wheels see).
3. Get drain capacity under the connection union to a support of a hydraulic hose. Release штуцерный a socket and disconnect a hose from a support. At once закупорьте the open ends of a hose and the union for the purpose of minimisation of losses of a hydraulic liquid and in order to avoid hit in dirt system.

4. Turn out two fixing bolts and remove a support with ступичной assemblages.

Major repairs

Performance of regenerative repair of the failed support probably only with application firm ремнабора companies Citroyon. Track, that ремнабор corresponded to type of the support removed from the car. Pay attention to correctness of installation of each of components. New linings and уплотнители before installation grease with a hydraulic liquid. In the rest follow instructions of manufacturers.

Installation

 PERFORMANCE ORDER

1. Establish a support on the regular place, with demanded effort having tightened fixing bolts.
2. Connect a hydraulic hose and strongly tighten штуцерный a socket.
3. Establish brake Pads (Replacement колодок disk brake mechanisms of forward wheels see).
4. Connect a negative wire to the battery.
5. Pump over brake system (Prorolling of hydraulic system see).
6. Establish to the place of a wheel, lower the car on the earth and tighten wheel bolts with demanded effort.


On the main page