Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
- Brake system
   Prorolling of hydraulic system
   Replacement of hoses and tubes of a hydraulic path of brake system
   Replacement колодок disk brake mechanisms of forward wheels
   Replacement колодок disk brake mechanisms of back wheels
   Condition check, removal and installation of brake disks
   Removal, major repairs and installation of supports of disk brake mechanisms of forward wheels
   Removal, major repairs and installation of supports of disk brake mechanisms of back wheels
   Removal, major repairs and installation of the valve of management
   Removal and installation of a pedal of a foot brake
   Lay brake - the general data and adjustments
   Removal and installation of a control lever of a lay brake
   Removal and installation of cables of a drive of a lay brake
   Removal and installation of the gauge-switch of stoplights
   System of antiblocking of brakes (ABS) - the general information
   Removal and installation of components of system of antiblocking of brakes
+ Running gear and steering
+ Body and salon furnish
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of a pedal of a foot brake

Removal

 PERFORMANCE ORDER

1. Remove assemblage of the panel of devices (address to the Head the Body and salon furnish).
2. Where it is required remove for the purpose of providing of access an air line of system of heating of salon.
3. In the top part of a basic arm of a steering column block from проворачивания an axial bolt of a pedal of a foot brake and give a nut of its fastening.
4. Cautiously unhook a returnable spring. Try to remember an order of installation of a spring on pedal assemblage. Remove a pedal from a basic arm.
5. Disconnect electroconducting from the gauge-switch of stoplights and take a pedal from the car.

Installation

Installation is made upside-down. Track correctness of connection of a returnable spring. Do not forget to establish into place the panel of devices (address to the Head the Body and salon furnish).


On the main page