Citroen Xantia

1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open лючки access and disconnect electroconducting from the back combined lanterns built in at a door.
4. Release clamps both turn out fixing screws and remove the bottom panel of an internal upholstery of a door of a back.
5. Release clamps of fastening of an emphasis of a back shelf on panels of a lateral upholstery of a door of a back (beat out the central pins, then take clamps). Remove an emphasis.

6. Turn out fixing screws and remove lateral panels from a back door.

7. Disconnect electroconducting from the consumers of the electric power located in a door (including contact sockets from both parties of a heater of back glass). If the door is not replaced, tie up to plaits of electroconducting string pieces.
8. Accurately disconnect a hose of giving of a liquid of washing of back glass from a nozzle on assemblage of the electromotor of a screen wiper. Prepare for gathering of a spilt liquid. Liberate a hose from a door at the top together with an electroconducting plait.
9. Take from the top end face of a door rubber plugs of electroconducting through passage, then liberate from a door plaits of wires. Leave the tied up pieces of a string sticking out of apertures through passage.
10. Ask the assistant to take a door and serially release spring clamps of both telescopic emphasis. Liberate spherical hinges of an emphasis from reception nests on a door.

11. Screw fixing bolts and by means of the assistant remove a door of a back from the car. Transfer a door to a safe place.

1. By means of the assistant get a door on the regular place, screw and tighten fixing bolts.

2. The further installation is made in an order, the return to a dismantle order. Pay attention to following moments:
   a) Refuelling at a door of plaits of electroconducting is made by means of left passed through apertures of pieces of a string through passage;

   b) After door installation check up uniformity of its arrangement concerning adjoining кузовных panels. In case of need release adjusting bolts and make corresponding updating. Having achieved satisfactory result, do not forget to tighten adjusting screws;

   c) Having adjusted door position, check up serviceability of functioning of its locks. In case of need ослабьте fixing bolts (it is necessary to remove the back panel of furnish of a door - see Removal and installation of components of the lock of a door of a back) and in appropriate way correct position of locks.

1. Prop up a back door in open position.

2. By means of a screw-driver with a flat sting release a spring clamp of a spherical support of a telescopic emphasis on a door.

3. Take a clamp from a support.

4. Repeat procedure, having released the hinge from the opposite end of an emphasis. Remove an emphasis from the car.