Citroen Xantia

Since 1993 of release

Repair and car operation

Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
- Body and salon furnish
   Care of components of a body and the car bottom
   Care of an upholstery and carpet coverings of salon
   Repair of insignificant damages кузовных panels
   Repair seriously damaged кузовных panels
   Removal and installation of a forward bumper
   Removal and installation of a back bumper
   Removal, installation and cowl adjustment
   Removal and installation drive a cable отпускания the cowl lock
   Removal and installation of locks of a cowl
   Removal, installation and adjustment of doors
   Removal and installation of panels of an internal upholstery of doors
   Removal and installation of door handles and lock components
   Removal and installation of regulators Glass lifts door windows
   Removal, installation and adjustment of a door of a back and its telescopic emphasis
   Removal and installation of components of the lock of a door of a back
   Removal and installation of components of the uniform lock
   Removal and installation of components of the electric drive door Glass lifts
   Removal and installation of door rear-view mirrors and accompanying components
   Windscreen, glass of a door of a back and the other fixed glasses - the general information
   The top hatch - the general information
   External кузовная furnish
   Removal and installation of seats
   Removal and installation of seat belts
   Removal and installation of elements of internal furnish of salon
   Removal and installation of the central console
   Removal and installation of the panel of devices
   Control кузовные the sizes
+ Onboard electric equipment
+ Electric equipment schemes

Removal and installation of locks of a cowl



1. Remove a radiator lattice (furnish see External кузовная).
2. Mark position of the lock concerning the panel передка.

3. At removal right замковой assemblages turn out two fixing bolts and take the lock from the panel передка. After extraction from the panel disconnect an executive rod of the lock and (at a corresponding complete set) liberate the gauge-switch of the anticreeping alarm system.
A — Fixing bolts
In — the Gauge-switch of the anticreeping alarm system

4. On the left lock turn out two fixing bolts and disconnect the executive lever and приводной a cable.


Installation is made upside-down. Track combination of the landing labels put in the course of dismantle. Before to establish a radiator lattice, check up serviceability of operation of latches. In case of need ослабьте fixing bolts also adjust position of corresponding assemblage, achieving adequate functioning of the lock.

On the main page