Removal and installation of components of the uniform lock
The electronic block of management
Removal
The block is located under the central console.
Installation
Installation is made upside-down.
Door activators
Activators of the uniform lock are built in in замковые assemblages of doors (Removal and installation of door handles and lock components see).
The activator of the lock of a door of a back
|
|
|
1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open лючки access and disconnect electroconducting from the back combined lanterns built in a door.
4. Release clamps, turn out fixing screws and remove the panel of the bottom furnish of a door of a back. |
|
5. Turn out two fixing bolts. |
|
|
6. Take the door-lock activator, then disconnect from it electroconducting. |
|
|
7. Installation is made upside-down. |
|
The receiver of signals from a remote control
|
|
|
1. Accurately having hooked, remove the panel of a cover of the electromotor of a drive of the top hatch. |
|
|
2. Release clamps and remove the receiver of signals of panel DU of the uniform lock from the cover panel, disconnect electroconducting. |
|
|
3. Installation is made upside-down. |
|
Panel DU batteries
|
|
|
1. Turn out the small self-cut screw in a back part of assemblage of the transmitter. Extend the transmitter from a back cover for the purpose of providing of access to batteries.
2. Take batteries (try to remember their correct adjusting position).
3. In the correct image establish two new batteries, establish into place a cover and tighten саморез. |
|
|