Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   - 4.1. Engine OHV (with a camshaft in the block of cylinders)
      4.1.1. A technical characteristics
      4.1.2. Compression check
      4.1.3. The repair operations which are not demanding removal of the engine
      + 4.1.4. The repair operations demanding removal of the engine
      4.1.5. Adjustment of backlashes of valves
      + 4.1.6. A head of the block of cylinders
      4.1.7. Removal and installation of the oil pallet
      + 4.1.8. The oil pump
      + 4.1.9. Mechanism asterisks timing
      + 4.1.10. Pistons and rods
      4.1.11. Removal and flywheel installation
      4.1.12. Removal and installation of support of the power unit
      4.1.13. Removal and installation of a camshaft and pushers
      4.1.14. Removal and installation of a back sealing ring of a cranked shaft
      4.1.15. Removal and installation of a cranked shaft and radical bearings
      + 4.1.16. Check of elements of the engine
      4.1.17. System of greasing of the engine
      4.1.18. Removal and engine installation
      4.1.19. Start of the engine after major repairs
   + 4.2. Engines OHC
   + 4.3. Engine DOHC with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.1.12. Removal and installation of support of the power unit Removal

PERFORMANCE ORDER
1. The power unit leans against three support. One on the right party supports the engine, one on the left side supports a transmission and the third in the centre supports a back part of the power unit.
2. For removal of a support of the engine or a transmission establish about a corresponding support a jack and raise so that the weight of the power unit was perceived by a jack.
3. Unscrew bolts, fastening a support of the power unit to the engine or a transmission and a body, and remove a support with a corresponding rubber pillow.
4. For removal of a back support lift a forward part of the car and fix on supports.
5. Support the power unit under differential a jack through wooden брусок.
6. Unscrew two bolts, fastening a support to the body bottom, and unscrew a nut and a bolt, fastening a rubber pillow to a support. Moving a rubber pillow back, remove it from a support and take from under the car.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal. Tighten bolts of fastening of support of the power unit the demanded moment. Carving apertures for bolts clear a corresponding tap. Before ввинчиванием bolts put on a carving of bolts the means interfering unscrewing of bolts.
2. If on a back support there is an arrow at installation of the marksman should be directed forward.


On the main page