| 1. Remove a head of the block of cylinders, the oil pallet and the oil pump. |
| 2. New covers of rods are not marked, therefore check up presence on them of labels and, at their absence, put them, beginning numbering from outside a drive. |
| 3. Unscrew bolts of fastening of covers of rods and arrange them so that at installation they have risen on the places. |
| 4. Remove covers of rods from rods. |
| 5. If necessary take шатунные loose leaves from a rod and rod cover. Have loose leaves so that at installation they have risen on the places. |
| 6. Pistons with rods are necessary for taking through the top part of the engine, pushing out their handle of a hammer. If there is a deposit in the top part of the cylinder, remove its scraper from a soft material. Step presence in the top part of the cylinder testifies to excessive deterioration of the cylinder and necessity расточки engine cylinders. |
| 7. It is not recommended to separate needlessly pistons from rods. Because a piston finger запрессован in a rod, for its removal and installation use of the special equipment is necessary. |
| 8. If pistons are necessary for removing from rods, put on the pistons of a label located from the same party, as a label on a rod. |