Opel Kadett E

1984-1991 of release

Repair and car operation


Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   - 4.1. Engine OHV (with a camshaft in the block of cylinders)
      4.1.1. A technical characteristics
      4.1.2. Compression check
      4.1.3. The repair operations which are not demanding removal of the engine
      + 4.1.4. The repair operations demanding removal of the engine
      4.1.5. Adjustment of backlashes of valves
      + 4.1.6. A head of the block of cylinders
      4.1.7. Removal and installation of the oil pallet
      + 4.1.8. The oil pump
      + 4.1.9. Mechanism asterisks timing
      + 4.1.10. Pistons and rods
      4.1.11. Removal and flywheel installation
      4.1.12. Removal and installation of support of the power unit
      4.1.13. Removal and installation of a camshaft and pushers
      4.1.14. Removal and installation of a back sealing ring of a cranked shaft
      4.1.15. Removal and installation of a cranked shaft and radical bearings
      + 4.1.16. Check of elements of the engine
      4.1.17. System of greasing of the engine
      4.1.18. Removal and engine installation
      4.1.19. Start of the engine after major repairs
   + 4.2. Engines OHC
   + 4.3. Engine DOHC with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.1.19. Start of the engine after major repairs
PERFORMANCE ORDER
1. On the engine established in a motor compartment of the car, check up levels of engine oil and cooling liquid. Check up that all earlier removed wires and hoses are established on the places.
2. Disconnect an electric socket from the block of ignition and remove the relay of the fuel pump. Turn the engine a starter until the control lamp of pressure of oil will not go out, then connect an electric socket to the block of ignition and establish the relay of the fuel pump.
3. Start the engine. Engine start can be more long, than usually, because of switching-off of fuel system.
4. At engine work idling check up presence of leaks of the fuel, cooling liquid and oil. At this stage of work of the engine the smell and a smoke from нагретых engine parts can be observed at burning out of the oil which have got on the engine at assemblage.
5. The engine should idle until the cooling liquid will not heat up that will be felt through the top hose of a radiator. Then switch off the engine.

6. After engine cooling check up level of oil and cooling liquid.
7. At installation in the engine of new pistons, piston rings or bearings of a cranked shaft it is necessary to make the engine during run of the first 800 km. Do not maintain the engine with completely open throttle заслонкой or under the big loading at low frequency of rotation of the engine. It is recommended to replace oil and the oil filter in the end of the period обкатки.


On the main page