Opel Kadett E

1984-1991 of release

Repair and car operation

Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   - 4.1. Engine OHV (with a camshaft in the block of cylinders)
      4.1.1. A technical characteristics
      4.1.2. Compression check
      4.1.3. The repair operations which are not demanding removal of the engine
      + 4.1.4. The repair operations demanding removal of the engine
      4.1.5. Adjustment of backlashes of valves
      + 4.1.6. A head of the block of cylinders
      4.1.7. Removal and installation of the oil pallet
      + 4.1.8. The oil pump
      + 4.1.9. Mechanism asterisks timing
      + 4.1.10. Pistons and rods
      4.1.11. Removal and flywheel installation
      4.1.12. Removal and installation of support of the power unit
      4.1.13. Removal and installation of a camshaft and pushers
      4.1.14. Removal and installation of a back sealing ring of a cranked shaft
      4.1.15. Removal and installation of a cranked shaft and radical bearings
      + 4.1.16. Check of elements of the engine
      4.1.17. System of greasing of the engine
      4.1.18. Removal and engine installation
      4.1.19. Start of the engine after major repairs
   + 4.2. Engines OHC
   + 4.3. Engine DOHC with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.1.7. Removal and installation of the oil pallet Removal

1. Lift a forward part of the car and fix on supports.
2. Merge engine oil in the suitable container and establish маслосливную a stopper into place.
3. Unscrew bolts, fastening a protective plate of a flywheel, and lateral clamps and remove a plate.
4. Unscrew bolts and remove the oil pallet. If the pallet sits densely, bring down its plastic hammer.


1. Clear the oil pallet kerosene or suitable solvent and remove an external dirt and internal adjournment from the oil pallet. Clear of the rests of an old lining interfaced surfaces of the oil pallet and the block of cylinders of the engine. Check up, that surfaces were pure and dry. Also clear flutes in covers of bearings.
2. Put a hermetic layer on ledges картера and in a junction of forward and back radical covers of bearings.
3. Establish pith linings on ledges картера and in flutes of radical covers of bearings.
4. Put a hermetic layer on a lining and a surface interfaced to a lining in a junction of a cover of the radical bearing.
5. Establish the oil pallet and fix its bolts, having tightened them gradually and in diagonal sequence.
6. Establish a protective cover of a flywheel and fix its bolts. Lower the car on the earth and fill in in the engine engine oil.

On the main page