|
1. Disconnect a negative wire from the battery.
2. Disconnect electroconducting from the gauge-switch of disconnection of a chain of a starter.
3. Remove the gauge-switch.
4. Check up size of a course of a pedal of coupling, in case of need make necessary updating (see Has undressed Removal, service, installation and adjustment of a pedal of coupling).
|
|
5. Measure size выступания плунжера the gauge-switch in its extreme position, - if the result differs from value of 2+1.5 mm, replace the gauge-switch. |
6. Check up conductivity between its plugs № 1 and № 2 disconnected gauges-switches. At the released pedal of coupling the result of measurement should make more than 1 МОм, at squeezed out, - less than 1 Ohm.
7. The faulty gauge-switch is subject to replacement. |