Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
- Coupling
   Specifications
   - Flywheel and coupling
      Flywheel and coupling - the general information and check of a condition of components
      Removal, check of a condition and installation of components of assemblage of coupling
      Removal, check of a condition and installation выжимного the bearing and the lever of deenergizing of coupling
      Removal, check of a condition and installation of the executive cylinder of coupling
      Removal, service and installation of components of the main cylinder of coupling
      Check of a condition and replacement of connecting lines of a hydraulic path of a drive of coupling
      Check of level and replacement of a hydraulic liquid of a drive of deenergizing of coupling
      Removal of air from a hydraulic path of a drive of deenergizing of coupling
      Removal, service, installation and adjustment of a pedal of coupling
      Removal, installation and check of serviceability of a condition of the gauge-switch of disconnection of a chain of a starter
   + Приводные and карданный shaft, back differential
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

Removal, check of a condition and installation of the executive cylinder of coupling

 PERFORMANCE ORDER

1. Remove the air cleaner case (see the Head of the Power supply system and release).
2. Disconnect from the executive cylinder a hydraulic hose, - at once закупорьте the open ends of a hose and the reception union in order to avoid hit of a dirt in a hydraulic path.

3. Turn out fixing screws and remove the executive cylinder with картера РКПП.

Efforts of a tightening of carving connections, Nanometer

Т1: 18
Т2: 37

4. Attentively study a cylinder condition, - in case of detection of mechanical damages or signs of development of leaks, cylinder assemblage is subject to replacement.
5. Installation is made in an order, the return to an order of dismantle of components. Track, that all fixture has been tightened with demanded effort.

 Before installation contacting to the lever of deenergizing of coupling it is necessary to grease a surface of a rod of the cylinder with greasing of type Sunlight 2: P/N 003602010.

6. Remove from the cylinder air (see Has undressed Removal of air from a hydraulic path of a drive of deenergizing of coupling) and check up serviceability of functioning of coupling.


On the main page