Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
- Suspension bracket and steering
Specifications
+ Forward suspension bracket
+ Back suspension bracket
- Steering
Design and principle of functioning of elements of the hydrostrengthened steering drive - the general information
Adjustable safety steering column - the general information
Removal and steering wheel installation
Removal, check of a condition and installation карданного the hinge of a steering column
Removal, service and installation of a steering column
Removal, service and installation of the steering mechanism
Removal, installation and check of a condition of elements of hydraulic path ГУР
Removal, service and installation of the steering pump
Removal and installation of the tank of liquid ГУР
Check and replacement of liquid ГУР, removal of air from a hydraulic path
+ Wheel assemblages, suspension bracket geometry
+ Body
+ Onboard electric equipment
|
Removal, check of a condition and installation карданного the hinge of a steering column
REMOVAL
|
|
|
1. Tyre out the car on the lift.
2. Result forward wheels of the car in rectilinear position and remove a steering wheel (see Has undressed Removal and steering wheel installation).
3. Lift the car.
|
|
4. Turn out fixing bolts and remove карданный the hinge of a steering shaft, preliminary having marked its adjusting position. |
|
|
CHECK
|
|
|
|
1. Carefully wipe the hinge pure rags and examine on presence of signs of mechanical damages. Manually estimate degree of deterioration of bearings крестовины карданного the hinge, - in case of revealing a little appreciable axial люфта replace шарнирную assemblage. Also check up effort of resistance of the hinge to rotation (see in the same place), - limiting admissible value makes 0.3 Nanometers. |
2. By means of a dynamometer measure sizes of efforts of resistance of knees of the hinge to bending.
|
|
INSTALLATION
|
|
|
1. Make sure of straightforwardness of installation of forward wheels, then, having tracked correctness of combination болтовых apertures of a long collar шарнирной assemblages with reception sample, plant a long collar of the hinge on the end of a steering shaft equipped with notches.
2. A short collar of the hinge plant a pin of a shaft of a leading gear wheel of the steering mechanism (also equipped with notches), - besides track correctness of combination болтовых apertures with reception sample in a pin.
3. Lower the hinge down to an emphasis and temporarily establish and tighten a bolt of fastening of a short collar, - checks of correctness of landing of a bolt in sample pull the hinge upwards.
4. Tighten with demanded effort (24 Nanometers) a coupling bolt of a long collar, then with the same effort definitively tighten a bolt of a short collar.
|
|
The tightening of coupling bolts of collars карданного the hinge with excessive effort is fraught with difficulties at steering wheel rotation! The size of a landing backlash between the hinge of double indemnification and the steering mechanism should make not less than 15 mm. |
5. The further installation is made in an order, the return to an order of dismantle of components. |
|
|
On the main page
|