Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
+ Systems of cooling, heating
- The power supply system and release
   Specifications
   - System of injection of fuel
      Sbrasyvanie pressure in the power supply system
      Опорожнение a fuel tank
      Check of a condition and replacement of fuel lines and them штуцерных connections
      Service of components of an inlet air path
      Removal and installation of the case of a throttle
      Service of components of a drive throttle заслонки
      Removal, service and installation of the inlet pipeline
      Service of the fuel pump
      Removal and installation of main relay MFI
      Removal and installation of the relay of the fuel pump
      Removal and installation of the gauge of a stock of fuel
      Removal and installation of the gauge of level of fuel in the additional chamber of a fuel tank
      Removal, check and installation of the fuel filter
      Removal and installation запорного the valve отсечки fuel
      Removal and installation демпфирующих fuel valves
      Removal and installation of a fuel tank
      Removal and installation of a jellied mouth of a fuel tank
      Removal and installation of components of system of injection of fuel
   + Control systems of the engine and decrease in toxicity of the fulfilled gases
   + System of release of the fulfilled gases
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Опорожнение a fuel tank

 PERFORMANCE ORDER

 The prevention in pressure Razdela Sbrasyvanie beginning in the power supply system see!

1. Tyre out the car on the lift.
2. Disconnect a negative wire from the battery.
3. Lift the car.

4. Remove the right panel of protection of a fuel tank.

5. Get under the car drain capacity approaching on volume, turn out a drain stopper of the main chamber and wait the terminations вытекания fuel.

6. Screw a stopper into place and tighten it with demanded effort (26 Nanometers).
7. Establish into place the protective panel and tighten bolts of its fastening with effort of 18 Nanometers.

8. Lower the car on the earth, lift a pillow of a back seat and unbend a carpet covering. Uncover a service aperture of access to the additional chamber of a fuel tank.

9. Disconnect electroconducting from the gauge of level of fuel in the additional chamber.

10. Disconnect a hose from the pumping pump.

11. Give fixing nuts and take assemblage of the gauge of level of fuel.

12. Pump out fuel from the additional chamber of a tank by means of the suitable MANUAL pump.

 Do not use for pumping out from a fuel tank electric or petrol pump stations!

13. Establish into place the gauge of level and tighten nuts of its fastening with demanded effort (4.4 Nanometers).
14. Restore initial connection of electric and fuel lines.
15. Establish into place a cover of a service aperture.
16. Lay on a place the unbent site of a carpet covering and lower a back seat.

On the main page