Audi A3

Since 1997 of release

Repair and car operation



Audi A3
+ The maintenance instruction
- Current leaving and service
   The routine maintenance schedule
   The general information on adjustment
   Check of levels of liquids, the control of leaks
   Check of a condition of tyres and pressure in them
   Replacement of impellent oil and the oil filter
   Check of a gear belt of drive ГРМ on presence of damages, deterioration measurement
   Check of brake system
   Check of fuel system
   Rotation and replacement of wheels. Chains противоскольжения
   Check of a condition and replacement of hoses of an impellent compartment, localisation of leaks
   Check of functioning of system of cooling
   Check of a condition of system of release of the fulfilled gases
   Visual check of tightness of a box of a gear change
   Check of a condition of components of a suspension bracket and steering
   Check of a condition of protective covers of power shafts
   Greasing of clamps of doors and the lock cylinder
   Condition check, adjustment and replacement of brushes of screen wipers
   The visual control of a seat belt and the block of a pillow of safety
   Check of a condition of the battery, care it and gymnastics
   Level check трансмиссионного oils РКПП
   Replacement of the filter of air of salon
   Replacement of a filtering element of the air filter
   Replacement of a brake liquid
   Check and replacement of spark plugs
   Replacement of the fuel filter of the diesel engine
   Check of level of a liquid of system of hydrostrengthening of a wheel
   Check of level of a liquid of the main transfer of automatic transmission
   Oil replacement in coupling Haldex of models with a full drive
   Condition check drivers ridge belts
   Level check трансмиссионной liquids АТ
+ The engine
+ Systems of cooling, heating
+ The power supply system and release of the fulfilled gases
+ Engine electric equipment
+ Manual box of a gear change
+ Automatic transmission and models with a full drive
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electroschemes





Check of a gear belt of drive ГРМ on presence of damages, deterioration measurement

THE GENERAL DATA

Measurement of deterioration of a belt on the diesel engine

The diesel engine

It will be necessary for carrying out of work for you:

– A calliper,
– A gear belt and a tension roller (if necessary).

Even if the belt is not worn out, it is necessary to make replacement each 60 00 km of run.

Check

PERFORMANCE ORDER
1. Open 3 скобы fastenings of the top part of a protective cover of a belt.
2. Take a cover above a little aside so that the belt was visible.
3. Measure by a calliper width of a belt – and-. If the width of a belt less than 22 mm, it means that the belt has reached a limit of deterioration and it is necessary to replace it (address to an accompanying illustration).
4. Replace a gear belt and a tension roller, for this purpose address to subsection Installation of the piston of the first cylinder in ВМТ.
5. Fix скобами the top protective cover of a belt.
6. If the gear belt was replaced, on a cowl inside fix a label with new date of replacement of a belt.
On the main page