|
1. Disconnect a negative wire from the battery.
2. Remove casings of a steering column (address to the Head the Body and salon furnish).
3. Open a cover of the assembly block for the purpose of providing of access to the screw of fastening of the angular panel of furnish “торпедо” from the driver's party of the car. |
|
4. Turn out the top and bottom fixing screws, delay the panel forward and disconnect from it electroconducting. Try to remember an order of connection of contact sockets. Remove the panel. |
|
|
5. Turn out three screws/release clamps of fastening of the panel of the switches located under an instrument guard. Liberate a left-hand side of the panel from “торпедо”, pull assemblage on itself and disconnect electroconducting from switches. Try to remember an order of connection of contact sockets. Remove the panel.
6. Take from the panel of devices an ashtray.
7. Turn out two bottom fixing screws, accurately having hooked a small screw-driver, release clamps and remove facing of control panels by radio tape recorder/heater functioning.
8. Having hooked a small screw-driver, remove from the panel of devices deflectors central ventilating nozzles. |
|
9. Turn out two fixing screws and take from the panel of devices a casing snuffled. Disconnect electroconducting from located in the central part “торпедо” switches, hours and, at a corresponding complete set, a control lamp of the anticreeping alarm system/gauge of temperature of air in car salon. |
|
|
10. From the back party of the panel release clamps and push out outside hours. |
|