Removal and installation drive a cable of a speedometer/gauge of speed
|
|
Some of models are equipped by a speedometer of electronic type with the gauge of speed established on a transmission which replaces with itself тросовый a drive used in system of mechanical type. |
Trosovyj drive
Removal
|
|
|
1. In an impellent compartment take a fastening pin drive a cable on картере transmissions. Disconnect from transmission a cable tip.
2. Sharply extend приводной a cable for the purpose of liberation of its spherical tip from the directing plug in a partition of an impellent compartment.
3. Involve a cable in an impellent compartment and remove it from the car. Try to remember a route of a lining of a cable and a site of its intermediate directing clamps. |
|
Installation
Installation is made upside-down. Before landing grease шаровый a cable tip with a soap solution. Track correctness of a lining of a cable and its landing in the plug through passage in a partition.
The gauge of speed
Removal
|
|
|
1. To steal up to the gauge is the most easier from under the car. For the purpose of simplification of access prop up противооткатными boots back wheels, then поддомкратьте redock of the car and establish it on props.
2. Disunite a contact socket of electroconducting of the gauge of speed.
3. Turn out a fixing bolt and remove the gauge together with a thermofilter. |
|
Installation
Installation is made upside-down. Make sure of serviceability of a condition of a sealing ring in the gauge basis, in case of need make its replacement. At a corresponding complete set do not forget to establish into place a gauge thermofilter.
|