Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of an electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation прикуривателя
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a small horn of a horn
   Removal and installation drive a cable of a speedometer/gauge of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety pillow - the general information, safety measures and system deactivation
   Removal and installation of components of a pillow of safety
   Diagnostics of systems of electronic control
+ Electric equipment schemes

Adjustment of optical axes of head headlights

Exact adjustment of optical axes of head block headlights is made by means of the special equipment in the conditions of a car-care centre workshop.

Approximate adjustment is made by rotation прутковым by a key of the adjusting screws located on an upper edge of each of block headlights.

 PERFORMANCE ORDER

1. Open a cowl and make necessary updating, rotating the corresponding adjusting screw through a panel aperture передка (pay attention that to the external screw to steal up from the back party of a block headlight if near at hand is not available enough long пруткового a key easier). The external screw serves for updating of position of a block headlight in a horizontal plane, internal - in vertical.
A Screws of adjustment of horizontal position of a block headlight
B Screws of adjustment of vertical position of a block headlight


 


On the main page