Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of an electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation прикуривателя
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a small horn of a horn
   Removal and installation drive a cable of a speedometer/gauge of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety pillow - the general information, safety measures and system deactivation
   Removal and installation of components of a pillow of safety
   Diagnostics of systems of electronic control
+ Electric equipment schemes

Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen

The new sealant of landing is required to a protective cover on a windscreen.

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Before a battery detachment make sure that the screen wiper brush occupies parking position.
3. Remove the screen wiper lever (Removal and installation of the lever of a screen wiper see).

4. Turn out fixing screws/release the clamps located from both parties of a protective cover of a drive of a screen wiper.

5. With a fine edge accurately cut a sealant located between the panel of a cover of a drive and a surface of a windscreen.

6. At a corresponding complete set uncover the isolating gauge-switch of the anticreeping alarm system with a sealing ring.

7. Take the gauge-switch from a cover of a drive of screen wipers. Remove the cover panel.

8. Turn out six fixing bolts and liberate assemblage of the electromotor with приводными draughts.



9. Disconnect electroconducting and remove приводную assemblage from the car.

Installation

Installation is made upside-down. Do not forget to replace a sealant established between a cover of a drive and a windscreen. The description of procedure of installation of the lever of a screen wiper is resulted in section Removal and installation of the lever of a screen wiper.


On the main page