1. Disconnect a negative wire from the battery.
2. Remove a steering wheel (address to the Head the Running gear and a steering).
3. Remove casings of a steering column (address to the Head the Body and salon furnish).
4. Open a cover of the assembly block of safety locks for the purpose of providing of access to the screw of fastening of lateral angular finishing section from the driver's party of the panel of devices.
5. Turn out the top and bottom screws of fastening of the angular finishing panel, pull the panel on itself and disconnect electroconducting of switches. Try to remember an order of connection of contact sockets. Remove the panel.
6. Turn out three screws/release clamps of fastening of the finishing panel of the switches located under an instrument guard. Liberate a left edge of the panel from “торпедо”, then pull assemblage on itself and disconnect electroconducting from switches. Try to remember an order of connection of contact sockets. Remove the panel.
7. Turn out two bottom fixing screws and one top, then pull an instrument guard on itself and disconnect electroconducting of a combination of devices.
Installation
Installation is made upside-down. The description of procedure of landing to a regular place of a steering wheel is resulted in the Head the Running gear and a steering.