Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of an electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation прикуривателя
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a small horn of a horn
   Removal and installation drive a cable of a speedometer/gauge of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety pillow - the general information, safety measures and system deactivation
   Removal and installation of components of a pillow of safety
   Diagnostics of systems of electronic control
+ Electric equipment schemes





Removal and installation of components of an instrument guard

 PERFORMANCE ORDER

1. Remove an instrument guard (Removal and installation of an instrument guard see).

Measuring instruments

 PERFORMANCE ORDER

1. Extend the button of dump of the counter of current kilometric area from a forward part of an instrument guard.
2. Release fixing clamps, turn out screws and remove assemblage of the panel of facing of an instrument guard with protective glass.

3. Access to all measuring instruments, except a speedometer is provided by removal of a back cover of a combination of devices (give fixing screws).
A — the Back cover of a combination of devices
B Screws of fastening of assemblage of a speedometer

4. Give fixing screws or nuts and remove a corresponding measuring instrument. Pay attention that fastening of some measuring instruments is carried out by means of clamps of its contact sockets.

5. Installation is made upside-down.

Control lamps and lamps of illumination of devices

 PERFORMANCE ORDER

1. Turn a cartridge of the failed lamp counter-clockwise and take it from assemblage of a combination of devices. Lamps are replaced in gathering with cartridges.


On the main page