Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of an electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation прикуривателя
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a small horn of a horn
   Removal and installation drive a cable of a speedometer/gauge of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety pillow - the general information, safety measures and system deactivation
   Removal and installation of components of a pillow of safety
   Diagnostics of systems of electronic control
+ Electric equipment schemes

Removal and installation of the aerial of a radio receiver

Aerial mast

The mast is simply turned out from the basis of antenna assemblage.

Antenna cable

 PERFORMANCE ORDER

1. For providing of access to the top end of antenna assemblage give a nut of fastening of its basis. It is necessary to remove a ceiling upholstery, therefore procedure performance it will be reasonable to charge to the expert (address to the Head the Body and salon furnish).
2. Having provided access to the aerial basis, give a nut and disconnect a cable.
3. The cable is laid across a roof of the car and goes down under the panel of devices on right forward кузовной to a rack. For providing of access to intermediate clamps of fastening of a cable, probably, it is necessary to remove “торпедо” (address to the Head the Body and salon furnish).
4. Remove assemblage of a radio tape recorder and disconnect an antenna cable from its back panel.
5. Try to remember a route of a lining of a cable.
6. Installation is made upside-down.



On the main page