Citroen Xantia

Since 1993 of release

Repair and car operation



Citroen Xantia
+ Introduction
+ The operation manual
+ Routine maintenance
+ Engine repair
+ Systems of cooling, heating
+ The power supply system and release
+ Engine electric equipment
+ Coupling
+ Transmission
+ Power shafts
+ Uniform hydraulic system
+ Brake system
+ Running gear and steering
+ Body and salon furnish
- Onboard electric equipment
   Search of causes of failures of an electric equipment
   Safety locks and the relay - the general information
   Removal and installation of switches
   Replacement of lamps of external lighting and alarm devices
   Replacement of lamps of internal lighting devices
   Removal and installation of external lighting and alarm devices
   Adjustment of optical axes of head headlights
   Removal and installation of an instrument guard
   Removal and installation of components of an instrument guard
   Removal and installation of hours
   Removal and installation прикуривателя
   Alarm system “do not forget to switch off lighting devices” - the general information
   Removal and installation of a small horn of a horn
   Removal and installation drive a cable of a speedometer/gauge of speed
   Removal and installation of the lever of a screen wiper
   Removal and installation of the electromotor and draughts of a drive of a cleaner of a windscreen
   Removal and installation of the electromotor of a drive of a back screen wiper
   Removal and installation of components of system of washing of glasses and lenses of head block headlights
   Removal and radio tape recorder installation
   Removal and installation of loudspeakers
   Removal and installation of the aerial of a radio receiver
   Anticreeping system - the general information
   Safety pillow - the general information, safety measures and system deactivation
   Removal and installation of components of a pillow of safety
   Diagnostics of systems of electronic control
+ Electric equipment schemes

Removal and installation of the electromotor of a drive of a back screen wiper

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Open a back door.
3. Open a cover of access and disconnect electroconducting from the back combined lanterns built in at a door.
4. Release fixing clamps/turn out screws and remove the bottom panel of an internal upholstery of a door of a back.
5. Having hooked, remove a protective cap шпиндельной nuts of the lever of a screen wiper, disconnect from a spindle a socket of a hose of giving of a washing liquid.
6. Give a nut and remove the lever from a spindle.

7. Give a nut of fastening of a spindle and remove a plastic cover and a sealant.

8. Disconnect from the union on the back parties drive the electromotor a hose of giving of a washing liquid.

9. Disunite two contact sockets of electroconducting on assemblage drive the motor.

10. Turn out four fixing bolts.

11. Remove приводную assemblage.

12. At desire the electromotor can be removed with приводной assemblages after отдавания fastening nuts (A) its spindle to draught, and also three bolts of fastening (B) the motor.

Installation

Installation is made upside-down.


On the main page