Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   + 4.1. Engine OHV (with a camshaft in the block of cylinders)
   - 4.2. Engines OHC
      4.2.1. A technical characteristics
      4.2.2. Compression check
      + 4.2.3. The repair operations demanding removal of the engine
      4.2.4. Removal and installation of auxiliary elements of the engine
      4.2.5. Removal and installation of the valve of adjustment of pressure of oil
      + 4.2.6. A gear belt
      + 4.2.7. A head of the block of cylinders
      4.2.8. Removal and camshaft installation
      4.2.9. Removal and installation of the oil pallet
      + 4.2.10. The oil pump
      4.2.11. Removal and installation of pistons and rods
      4.2.12. Removal and flywheel installation
      4.2.13. Removal and installation of a forward sealing ring of a cranked shaft
      4.2.14. Removal and installation of support of the power unit
      4.2.15. Replacement of a back sealing ring of a cranked shaft
      + 4.2.16. A cranked shaft and radical bearings
      4.2.17. Check of details of the engine
      4.2.18. System of greasing and ventilation system картера
      4.2.19. Removal and engine installation
      4.2.20. Start of the engine after major repairs
   + 4.3. Engine DOHC with 16 valves
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes

4.2.13. Removal and installation of a forward sealing ring of a cranked shaft Removal

PERFORMANCE ORDER
1. Remove a gear belt. On engines 1,6 (16 SH), 1,8 and 2,0 l are necessary to unscrew a bolt of fastening of a pulley of a cranked shaft and to remove a pulley and linings, having noted their arrangement.
2. On later models remove other pulleys of a gear belt, then unscrew bolts and remove a back casing of a gear belt.
3. Using edges of two screw-drivers as levers, remove a pulley of a cranked shaft and segment шпонку.
4. Drill in a sealing ring two small apertures located in the opposite ends of a sealing ring. Screw in two self-cutting screws in the drilled apertures of a sealing ring and, using flat-nose pliers, extend for heads of screws a sealing ring.
5. Clear a nest for a sealing ring.

Installation

PERFORMANCE ORDER
1. Dip a new sealing ring into pure engine oil and, using tubular оправку the corresponding diameter, establish a sealing ring in a nest on demanded depth. Preliminary close a sticky tape an end face of a cranked shaft not to damage working edges of a sealing ring at installation.
2. Remove a sticky tape from a cranked shaft.
3. Establish a back casing of a gear belt, a gear belt and adjust its tension.


On the main page