Opel Kadett E

1984-1991 of release

Repair and car operation



Opel Kadett E
+ 1. The maintenance instruction
+ 2. Weekly checks and service in a way
+ 3. Maintenance service
- 4. The engine
   + 4.1. Engine OHV (with a camshaft in the block of cylinders)
   + 4.2. Engines OHC
   - 4.3. Engine DOHC with 16 valves
      4.3.1. A technical characteristics
      4.3.2. Compression check
      + 4.3.3. The operations demanding removal of the engine
      4.3.4. Removal of auxiliary components of the engine
      4.3.5. Removal and installation of the valve of adjustment of pressure of oil
      - 4.3.6. A gear belt
         4.3.6.1. Removal of a gear belt
         4.3.6.2. Installation of a gear belt
         4.3.6.3. Adjustment of a gear belt
      4.3.7. Removal and installation of the mechanism of a tension of a gear belt and rollers
      4.3.8. Removal, check and installation of camshafts
      + 4.3.9. A head of the block of cylinders
      4.3.10. Removal and installation of the oil pallet and маслоотражательной plates
      + 4.3.11. The oil pump
      4.3.12. Removal and installation of the valve of the thermostat of an oil radiator
      + 4.3.13. Pistons and rods
      4.3.14. Removal and flywheel installation
      + 4.3.15. Replacement of sealing rings
      4.3.16. Removal, check and installation of bearings of a cranked shaft
      4.3.17. Check of components of the engine
      4.3.18. Removal and engine installation
      4.3.19. Start of the engine after major repairs
   + 4.4. Diesel engines 16D and 16DА
   + 4.5. Diesel engines of 1,7 l
+ 5. System of cooling, heating and ventilation
+ 6. Fuel and exhaust systems
+ 7. Start and gymnastics system
+ 8. Ignition system
+ 9. Coupling
+ 10. Transmissions and power shafts
+ 11. Brake system
+ 12. A suspension bracket and a steering
+ 13. A body
+ 14. Electric schemes





4.3.6.2. Installation of a gear belt
PERFORMANCE ORDER
1. Temporarily establish a pulley auxiliary drive a belt of a cranked shaft. Check up that adjusting labels on pulleys of a cranked shaft and camshafts are combined with indexes. Remove a pulley auxiliary drive a belt from a cranked shaft.
2. Establish a gear belt on pulleys, since a pulley of a cranked shaft.
3. Establish a pulley of a cranked shaft and fix bolts, having tightened their demanded moment. At a tightening of bolts of fastening of a pulley keep a cranked shaft from проворачивания in the same way, as well as at unscrewing of bolts.
4. Adjust a tension of a gear belt. For measurement of a tension of a gear belt it is necessary to use special tool Opel № КМ-666 (fig. Special tool Opel № КМ-666 for measurement of a tension of a gear belt see). In the absence of this tool the tension of a gear belt can be adjusted manually approximately but after that it is necessary to address as soon as possible on servicing deport for adjustment of a correct tension of a gear belt.

On the main page