Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   + System of cooling of the engine
   - Heating/ventilation/air conditioning systems
      Removal and installation дефлекторов and air lines
      Removal and installation of resistive assemblage drive the electromotor of the fan of a heater
      Removal, check and installation drive the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assemblage of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Compressor K/V - a design and a functioning principle
      Condenser K/V - a design and a functioning principle
      Receiver-dehumidifier К/В - a design and a functioning principle
      The gauge-switch of pressure К/В - a design and a functioning principle
      Evaporator K/V - a design and a functioning principle
      Broad valve K/V - a design and a functioning principle
      Condition check, removal and installation of the compressor of system K/V
      Removal and installation of the condenser of system K/V
      Removal and installation of a receiver-dehumidifier of system K/V
      Removal and installation of the inlet block of system K/V, evaporator replacement
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the gauge-switch of pressure
      Removal and installation of information gauges of system of an automatic central air (climate control)
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of a receiver-dehumidifier of system K/V

 PERFORMANCE ORDER

1. Make a discharge of a central air in the conditions of a specialised workshop.
2. Disconnect a negative wire from the battery.

3. Disconnect from assemblage of a receiver-dehumidifier electroconducting of the gauge-switch of pressure () and a tube (), then turn out fixing bolts () and remove a receiver.

The receiver-dehumidifier is filled сиккативом, in order to avoid hit in наполнитель a moisture at once закупорьте open unions of assemblage.

If the receiver-dehumidifier is subject to replacement, add in the compressor corresponding quantity of refrigerator oil (5 ml).


And — the Contact socket of electroconducting of the gauge-switch of pressure
In — the Tube
With — Fixing bolts

4. Installation is made upside-down. Do not forget to replace sealing rings.

 The central air recharge should be made in the conditions of a car-care centre workshop.

On the main page