Subaru Legacy/Outback

1999-2003 of release

Repair and car operation



Subaru Legasi, Autbek
+ Cars Subaru Legacy, Outback
+ The operation manual
+ Routine maintenance
+ The engine
- Systems of cooling, heating
   Specifications
   + System of cooling of the engine
   - Heating/ventilation/air conditioning systems
      Removal and installation дефлекторов and air lines
      Removal and installation of resistive assemblage drive the electromotor of the fan of a heater
      Removal, check and installation drive the electromotor of the fan of a heater
      Removal and installation of the control panel by functioning of systems of heating/ventilation/air conditioning
      Removal and installation of assemblage of a heater
      Removal and installation of the heat exchanger of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Compressor K/V - a design and a functioning principle
      Condenser K/V - a design and a functioning principle
      Receiver-dehumidifier К/В - a design and a functioning principle
      The gauge-switch of pressure К/В - a design and a functioning principle
      Evaporator K/V - a design and a functioning principle
      Broad valve K/V - a design and a functioning principle
      Condition check, removal and installation of the compressor of system K/V
      Removal and installation of the condenser of system K/V
      Removal and installation of a receiver-dehumidifier of system K/V
      Removal and installation of the inlet block of system K/V, evaporator replacement
      Replacement of connecting hoses of a refrigerator path
      Check of serviceability of functioning of the gauge-switch of pressure
      Removal and installation of information gauges of system of an automatic central air (climate control)
+ The power supply system and release
+ Engine electric equipment
+ Manual box and differential
+ Automatic transmission
+ Coupling
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal, check and installation drive the electromotor of the fan of a heater

REMOVAL

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.
2. Remove a ware box (the Body see the Head).

3. Turn out bolts of fastening of a basic arm of a plait of electroconducting.

4. Give nuts of racks of the block of remote control of the uniform lock and block CRU.

5. Disunite a contact socket of the electric drive of the top hatch.

6. Disunite a contact socket of electroconducting of the servo-driver.

7. Disconnect electroconducting from the electromotor of a drive of the fan.

8. Turn out three fixing screws, disconnect аспираторную a tube () and remove the electromotor.

And — Aspiratornaja a tube

CHECK

 PERFORMANCE ORDER

Connect the plug №1 contact sockets of the electromotor to a positive pole of the storage battery, the plug №2 earth. Make sure of smoothness of rotation of the motor.

INSTALLATION

 PERFORMANCE ORDER

Installation is made in an order, the return to an order of dismantle of components.

On the main page